UCS512 SOP8 IC for DMX 5v 12v 24v rgb leds chip Components

This pixel protocol was designed by Lianxinke in China. It uses a non-differential DMX512 protocol to drive pixel chips. The control circuit comes in a SOP8 package, allowing for more flexibility with LED choice.

can be used for DC5V/DC12V/DC24V RGB DMX LED Strip

Support

Note: When configuring your pixel device, select 'DMX512' as your Pixel Type. This is the equivalent protocol that will allow you to use UCS512B pixels.

Technical Specifications

Clock Type	Data-Only
Color Resolution	8 bits
Physical Package	SOP8
RGB	Yes
RGBW	See UCS2904
Output Pixel Voltage	5 – 24V
PWM Rate	3000Hz
Suitable Camera	Up to 100fps, see Refresh Rate and PWM Rate
Data Transfer Rate	250 – 750kbps
Redundant Data Line	No

UCS512B Advantages

• High PWM rate allows for filming these pixels with cameras up to 100fps
• Up to 24V, allowing for very long cable lengths

UCS512B Disadvantages

• Data-only restricts refresh rates to be limited by the speed of the protocol, which will generally be slow
• Only 8 bits of data for each color makes dimming curves less smooth
• No redundancy in data
• Operation relies on addressing of the pixels to be correct from the factory (See Operational Behavior below)