Chinese
English
Deutsch
Español
T1000S Digital LED Controller
T1000S Digital LED Controller:
1.can control 2048 pixel
2.DC5V/DC7.5V-24
3.led string, strip, pixel led
4. LEDEditor software
T1000S Digital LED Controller Software: 2019-LED Player_V4.3_Setup
T1000S Digital LED Controller:
1. 256 Gray,Gamma correction processing software.
2. Support the rules and special-shaped handle.
3. Controller, a port output, may bring 1024/2048 light.
4. Off-line control, play back content stored in the SD card
5. T-1000C store a maximum of 16 documentsVideo: https://www.youtube.com/watch?v=JWOI-ehVvXs
Support IC type
Module in LedEdit software
Pixel numbers
remark
LPD6803,D705,1101,6909, 6912
T-1000-6803
2048 pixel
LPD8806,LPD8809
T-1000-8806
2048 pixel
TM1803,TM1804,TM1809,TM1812
T-1000-TM
2048 pixel
TM1804 and TM1809
low speed and high speed
TM1903TM1904TM1909TM1912
T-1000-TM19
2048 pixel
UCS6909UCS6912UCS7009UCS5903
T-1000-UCS-32
2048 pixel
UCS1903UCS1909UCS1912
T-1000-UCS-256
2048 pixel
low speed and high speed
UCS3903
T-1000-UCS-1024
2048 pixel
DMX512
T-1000-DMX
170/512 pixel
Compatible DMX512
WS2801,WS2803
T-1000-WS
2048 pixel
WS2811
T-1000-WS2811
2048 pixel
low speed and high speed
DS189
T-1000-DS189
2048 pixel
TLS3001,TLS3002TLS3008
T-1000-TLS
* pixel
P9813
T-1000-P9813
2048 pixel
SM16715
T-1000-SM16715
2048 pixel
low speed and high speed
SM16716
T-1000-SM16716
2048 pixel
BS0901,BS0902
T-1000-0901
2048 pixel
BS0815
T-1000-0815
2048 pixel
Note:
Controller on the SD card can not be hot-swappable, plug the SD card every time, you must first disconnect the power supply controller
Question 1: After power, the T-1000 ERROR indicator has been flashing without display output
Answer: The ERROR indicator has been flashing means the controller did not read the card correctly, possible problems:
a .SD card is empty, with no effect file
b .The effect file in the SD card and the controller model are not match, please choose correct controller model in LedEdit and then re-create the effect file led
c .SD card did not format to FAT before copy effect files
d .Please check the supply power voltage, the controller can be individually powered to exclude power reasons
f .Changing the SD card and then test to exclude the possibility of a bad SD card
Question 2: The controller is powered on, the indicator is normal, but no effect change in lighting
Answer: The reasons for this are as follows:
A. Check if the lighting′s signal line and the controller connected correctly
B.If the TTL signal is received, the lamp and the controller must be common ground, that means connect the lighting′s and the controller′s ground together
C.check if the model chose during making display files on the SD card match the chips used in the lighting
- T1000S Digital LED Controller:
-
